Now it’s time to put everything together and make your dice box complete! If you’re only using glue then spread some on all four corners (the two round ones and the bottom pointy one). Don’t worry about the edges here, we’ll take care of that in Step Six. Use sandpaper on everything except the bottom of the box (which will have no opening later) then wipe them down with a wet paper towel until they’re nice and smooth. Now is when that comes back into play! Start cutting along your traced lines and try not to ruin those holes you drilled earlier by cutting too close or letting something slip! You can also use sandpaper here if it helps but this part should be pretty easy.Īfter all your pieces are cut out now they just need some fine-tuned finishing touches. Step Four: Cut Out the Inside of Your Dice BoxĪs you may recall, we used a hobby knife to cut out our design in step two. Make sure that there is at least an inch between these holes because we will be putting dowels through them later which should fit pretty snugly into those holes, so make sure they’re deep enough! Step Three: Trace Your Board and Drill HolesĪfter tracing your box onto your board (or if not using paper), place it where you want it and drill holes down each side about two inches away from the centerline. If you are using power tools now is the time to turn them on! Some people like to use glue here instead of cutting all-around their design but it’s up to you! You can use scissors or a hobby knife for this part. If using power tools is not something you are familiar with, at least try tracing first before moving on to Step Two so your pieces come together correctly and don’t turn out wonky! Now let’s get started making those dice boxes! Make sure you draw it big enough to fit onto your board! A pencil works well for this, but if you have a marker that will work better make sure to use that. Start by drawing your design on the center of the paper. How to make a dice box Step One: Draw Your Design If you know how to use power tools that will be even better! You can also skip some of the steps if you have something else on hand that will work. Optional but helpful: sandpaper and a pencil or marker for tracing onto your board. A sheet of paper to draw your design on (a print-out from the website works great!), some glue. Suggestions for how to customize your dice boxĪ small piece of wood, about an inch thick.Step Six: Put All Your Pieces Together!.Step Four: Cut Out the Inside of Your Dice Box.Step Three: Trace Your Board and Drill Holes.
0 Comments
Leave a Reply. |